Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER

REAR BUMPER > REMOVAL

for Preparation Click here



1. REMOVE REAR BUMPER PLATE LH


    B280037E01
  1. Using a screwdriver with the tip wrapped with protective tape, disengage the 2 claws.
    Text in Illustration 
    *1
    Protective Tape
    *2
    Hook

    HINT:
    Tape the screwdriver tip before use.

  1. Disengage the hook and remove the rear bumper plate LH.



2. REMOVE REAR BUMPER PLATE RH

HINT:
Use the same procedure as for the LH side.



3. REMOVE REAR BUMPER ASSEMBLY


    B280039E01
  1. Put protective tape around the rear bumper assembly.
    Text in Illustration 
    *1
    Protective Tape



    B280041
  1. Using a clip remover, remove the 2 clips.

  1. Remove the 6 screws.



    B280040
  1. Remove the 2 screws.

    HINT:
    Use the same procedure for the RH side and LH side.



    B280042
  1. Disengage the 7 claws as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.



    B280044
  1. Disengage the 6 claws as shown in the illustration.

  1. w/ Intuitive Parking Assist System:

    1. Disconnect the connector.

  1. Remove the rear bumper assembly.