Home › Engine / Hybrid System ยท 2GR-FE › ENGINE MECHANICAL › CYLINDER BLOCK

CYLINDER BLOCK > REPLACEMENT

for Preparation Click here



1. REPLACE STRAIGHT PIN


  1. Using a plastic hammer, tap in new straight pins to the cylinder block.


    A131842E09


    Text in Illustration 
    *a
    Front Cylinder Block
    *b
    Rear Cylinder Block
    *c
    Upper Cylinder Block
    *d
    Lower Cylinder Block
    *e
    Cylinder Block RH Side
    -
    -

    Standard Protrusion:
    Item
    Protrusion
    Pin A
    23 mm (0.906 in.)
    Pin B
    6 mm (0.236 in.)
    Pin C
    11 mm (0.433 in.)
    Pin D
    9 mm (0.354 in.)



2. REPLACE STUD BOLT


  1. Using an E8 and E10 "TORX" socket wrench, install the stud bolts.


    A134958E06


    Text in Illustration 
    *a
    Front Cylinder Block
    *b
    Cylinder Block LH Side

    Torque:
    Bolt A:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }
    Bolt B:
    17 N*m{ 173 kgf*cm , 13 ft.*lbf }