Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM

PARKING ASSIST MONITOR SYSTEM > DTC CHECK / CLEAR

for Preparation Click here



CHECK DTC
  1. Connect the Techstream to the DLC3.

  2. Turn the engine switch on (IG).

  3. Turn the Techstream on.

  4. Enter the following menus: Body Electrical / Navigation System / Trouble Codes.

  5. Check for DTCs, and then write them down.

  6. Check for DTCs (Click here).

    NOTICE:
    The audio and visual system outputs DTCs for the following system. When DTCs other than those in Diagnostic Trouble Code Chart for the audio and visual system are output, refer to Diagnostic Trouble Code Chart for the relevant system.
    System
    Proceed to
    Audio and visual system (for radio and display type with intuitive parking assist system)
    Click here


CLEAR DTC
  1. Connect the Techstream to the DLC3.

  2. Turn the engine switch on (IG).

  3. Turn the Techstream on.

  4. Enter the following menus: Body Electrical / Navigation System / Trouble Codes.

  5. Clear the DTCs.