Home › Engine / Hybrid System · 2AR-FE › ENGINE CONTROL › MASS AIR FLOW METER

MASS AIR FLOW METER > INSPECTION

for Preparation Click here



1. INSPECT MASS AIR FLOW METER SUB-ASSEMBLY


    A190679E11
  1. Perform a visual check for any foreign matter on the platinum hot wire (heater) of the mass air flow meter sub-assembly shown in the illustration.
    Text in Illustration 
    *1
    Platinum Hot Wire (Heater)

    OK:
    There is no foreign matter.



  1. Check the intake air temperature sensor (built into the mass air flow meter sub-assembly).



      A196153E09
    1. Measure the resistance according to the value(s) in the table below.
      Text in Illustration 
      *a
      Component without harness connected
      (Mass Air Flow Meter Sub-assembly)

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 (THA) - 2 (E2)
      -20°C (-4°F)
      13.6 to 18.4 kΩ
      1 (THA) - 2 (E2)
      20°C (68°F)
      2.21 to 2.69 kΩ
      1 (THA) - 2 (E2)
      60°C (140°F)
      0.49 to 0.67 kΩ

      If the result is not as specified, replace the mass air flow meter sub-assembly.