Home › Engine / Hybrid System ยท 2GR-FE › ENGINE CONTROL › ACTIVE CONTROL ENGINE MOUNT

ACTIVE CONTROL ENGINE MOUNT > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT FRONT ENGINE MOUNTING INSULATOR ASSEMBLY
  1. Check the operation.

    1. Connect the Techstream to DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the Techstream on.

    4. Enter the following menus: Powertrain / Engine / Active Test / Control the ACM Inhibit.

      Tester Display
      Test Part
      Control Range
      Diagnostic Note
      Control the ACM Inhibit
      ACM
      ON / OFF
      Test is possible while engine is idling

    5. Check if the front engine mounting insulator assembly operates in accordance with tester operation.

      Result:
      Condition
      Specified Condition
      "Control the ACM Inhibit" is OFF
      The engine does not move (insulator operation is normal).
      "Control the ACM Inhibit" is ON
      The engine moves in accordance with insulator operation.

      HINT:
      While "Control the ACM Inhibit" is ON, the front engine mounting insulator assembly operates repeatedly.



  1. Inspect for vacuum leaks.

    1. Disconnect the vacuum hose from the front engine mounting insulator assembly.



    2. A255001
    3. Using a vacuum pump, apply vacuum of 80 kPa (600 mmHg, 25 in.Hg) and wait for 1 minute.

    4. Check that there is no change in the needle movement of the vacuum pump gauge.

      OK:
      Vacuum pressure holds.

    5. Check that there is no fluid leakage caused by a break in the diaphragm.

    6. Reconnect the vacuum hose.