Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER

REAR BUMPER > DISASSEMBLY

for Preparation Click here



1. REMOVE NO. 2 LUGGAGE ROOM WIRE (w/ Intuitive Parking Assist System)


    B280047
  1. Disengage the 4 clamps.

  1. Disconnect the connector and remove the No. 2 luggage room wire.



2. REMOVE ULTRASONIC SENSOR CLIP (w/ Intuitive Parking Assist System)


    E228017E01
  1. Disconnect the connector.
    Text in Illustration 
    *A
    LH Side
    *B
    Other Side

  1. Disengage the clamp.



    E228018E01
  1. Disengage the 4 claws to remove the ultrasonic sensor clip.
    Text in Illustration 
    *A
    LH Side
    *B
    Other Side



3. REMOVE NO. 1 ULTRASONIC SENSOR (w/ Intuitive Parking Assist System)


    E228019E01
  1. Disengage the 2 claws to remove the No. 1 ultrasonic sensor.
    Text in Illustration 
    *A
    LH Side
    *B
    Other Side



4. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER (w/ Intuitive Parking Assist System)


    E228020E01
  1. Disengage the 2 claws to remove the No. 1 ultrasonic sensor retainer from the rear bumper assembly.
    Text in Illustration 
    *A
    LH Side
    *B
    Other Side



5. REMOVE REAR BUMPER SIDE RETAINER LH


    B280046
  1. Remove the 3 screws.

  1. Disengage the 6 claws and remove the rear bumper side retainer LH.



6. REMOVE REAR BUMPER SIDE RETAINER RH

HINT:
Use the same procedure as for the LH side.



7. REMOVE WHEEL HOUSE REINFORCEMENT LH
  1. Disengage the clip.



    B280052
  1. Remove the screw.

  1. Remove the nut and wheel house reinforcement LH.



8. REMOVE WHEEL HOUSE REINFORCEMENT RH

HINT:
Use the same procedure as for the LH side.



9. REMOVE REAR BUMPER ENERGY ABSORBER


    B280048
  1. Disengage the 2 guides and remove the rear bumper energy absorber.



10. REMOVE REAR BUMPER REINFORCEMENT SUB-ASSEMBLY


    B280049
  1. Remove the 6 nuts and rear bumper reinforcement sub-assembly.