Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER

REAR BUMPER > REASSEMBLY

for Preparation Click here



1. INSTALL REAR BUMPER REINFORCEMENT SUB-ASSEMBLY


    B280049
  1. Install the rear bumper reinforcement sub-assembly with the 6 nuts.

    Torque:
    61 N*m{ 622 kgf*cm , 45 ft.*lbf }



2. INSTALL REAR BUMPER ENERGY ABSORBER


    B280048
  1. Engage the 2 guides to install the rear bumper energy absorber.



3. INSTALL WHEEL HOUSE REINFORCEMENT LH


    B280052
  1. Install the wheel house reinforcement LH with the screw and nut.

  1. Engage the clip.



4. INSTALL WHEEL HOUSE REINFORCEMENT RH

HINT:
Use the same procedure as for the LH side.



5. INSTALL REAR BUMPER SIDE RETAINER LH


    B280046
  1. Engage the 6 claws.

  1. Install the rear bumper side retainer LH with the 3 screws.



6. INSTALL REAR BUMPER SIDE RETAINER RH

HINT:
Use the same procedure as for the LH side.



7. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER (w/ Intuitive Parking Assist System)


    E232468E01
  1. Engage the 2 claws to install the No. 1 ultrasonic sensor retainer to the rear bumper assembly.
    Text in Illustration 
    *A
    LH Side
    *B
    Other Side
    *a
    Keyhole
    *b
    Snap

    NOTICE:
    1. Do not damage the front bumper with the protrusion when installing the retainer.
    2. Securely install the No. 1 ultrasonic sensor retainer so that there are no gaps between the retainer and surface of the front bumper.

    HINT:
    When installing the retainer, align the keyhole and snap as shown in the illustration.



8. INSTALL NO. 1 ULTRASONIC SENSOR (w/ Intuitive Parking Assist System)


    E228019E01
  1. Engage the 2 claws to install the No. 1 ultrasonic sensor to the No. 1 ultrasonic sensor retainer.
    Text in Illustration 
    *A
    LH Side
    *B
    Other Side

    NOTICE:
    Push the No. 1 ultrasonic sensor retainer from the outside of the bumper when there is a gap between the retainer and the bumper surface. In this case, do not push on the ultrasonic sensor.



9. INSTALL ULTRASONIC SENSOR CLIP (w/ Intuitive Parking Assist System)


    E228018E01
  1. Engage the 4 claws to install the ultrasonic sensor clip.
    Text in Illustration 
    *A
    LH Side
    *B
    Other Side



    E228017E01
  1. Engage the clamp.
    Text in Illustration 
    *A
    LH Side
    *B
    Other Side

  1. Connect the connector.



10. INSTALL NO. 2 LUGGAGE ROOM WIRE (w/ Intuitive Parking Assist System)


    B280047
  1. Connect the 4 connectors.

  1. Engage the 4 clamps to install the No. 2 luggage room wire.