Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › CLEARANCE SONAR MAIN SWITCH

CLEARANCE SONAR MAIN SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY
  1. Engage the 2 claws to install the back sonar or clearance sonar switch assembly.



2. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


    B279864
  1. Temporarily install the instrument cluster finish panel assembly as shown in the illustration.

  1. Connect each connector.

  1. Engage the 5 claws, 5 clips and 2 guides, and install the instrument cluster finish panel assembly.



    B279861
  1. Engage the 2 claws, 4 clips and 2 guides.



3. INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY


    B280309
  1. Engage the 4 clips to install the No. 1 instrument panel register assembly.



4. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH


    B280308
  1. Engage the 3 clips to install the No. 1 instrument cluster finish panel garnish.



5. INSTALL INSTRUMENT SIDE PANEL LH
  1. Engage the 3 guides.



    B278009
  1. Engage the 4 claws to install the instrument side panel LH as shown in the illustration.



6. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH


    B278980E01
  1. Align the alignment mark (Yellow) on the weatherstrip with the protruding portion on the body indicated by the arrow in the illustration, and install the front door opening trim weatherstrip LH.
    Text in Illustration 
    *1
    Alignment Mark (Yellow)

    NOTICE:
    After installation, check that the corners fit correctly.