CLEARANCE SONAR MAIN SWITCH > REMOVAL |
| 1. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH |
![]() |
Disconnect the front door opening trim weatherstrip LH.
| 2. REMOVE INSTRUMENT SIDE PANEL LH |
![]() |
Using a moulding remover, disengage the 4 claws as shown in the illustration.
![]() |
Disengage the 3 guides and remove the instrument side panel LH as shown in the illustration.
| 3. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH |
![]() |
Disengage the 3 clips to remove the No. 1 instrument cluster finish panel garnish as shown in the illustration.
| 4. REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY |
![]() |
Apply protective tape to the area shown in the illustration.
| *1 | Protective Tape |
![]() |
Disengage the 2 clips as shown in the illustration.
![]() |
Using a moulding remover, disengage the 2 clips to remove the No. 1 instrument panel register assembly.
| 5. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY |
Operate the tilt and telescopic lever to fully extend and lower the steering column assembly.
![]() |
Using a moulding remover, disengage the 2 claws, 4 clips and 2 guides.
![]() |
Disengage the 5 claws, 5 clips and 2 guides.
Disconnect each connector.
![]() |
Remove the instrument cluster finish panel assembly as shown in the illustration.
| 6. REMOVE BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY |
![]() |
Disengage the 2 claws and remove the back sonar or clearance sonar switch assembly.