Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR MAIN SWITCH

BLIND SPOT MONITOR MAIN SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH


    B278007
  1. Disconnect the front door opening trim weatherstrip LH.



2. REMOVE INSTRUMENT SIDE PANEL LH


    B278008
  1. Using a moulding remover, disengage the 4 claws as shown in the illustration.



    B278010
  1. Disengage the 3 guides and remove the instrument side panel LH as shown in the illustration.



3. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH


    B278012
  1. Disengage the 3 clips to remove the No. 1 instrument cluster finish panel garnish as shown in the illustration.



4. REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY


    B278013E01
  1. Apply protective tape to the area shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape



    B279858
  1. Disengage the 2 clips as shown in the illustration.



    B279859
  1. Using a moulding remover, disengage the 2 clips to remove the No. 1 instrument panel register assembly.



5. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
  1. Operate the tilt and telescopic lever to fully extend and lower the steering column assembly.



    B279860
  1. Using a moulding remover, disengage the 2 claws, 4 clips and 2 guides.



    B279862
  1. Disengage the 5 claws, 5 clips and 2 guides.

  1. Disconnect each connector.



    B279863
  1. Remove the instrument cluster finish panel assembly as shown in the illustration.



6. REMOVE BLIND SPOT MONITOR MAIN SWITCH ASSEMBLY (WARNING CANCELING SWITCH ASSEMBLY)


    E226412
  1. Disengage the 2 claws to remove the blind spot monitor main switch assembly (warning canceling switch assembly).