SHIFT LEVER > INSPECTION |
| 1. INSPECT LOWER SHIFT LEVER ASSEMBLY |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 5 (IG) - Body ground | Engine switch on (IG) | 11 to 14 V |
| Engine switch off | Below 1 V | |
| 4 (STP) - Body ground | Brake pedal depressed | 11 to 14 V |
| Brake pedal released | Below 1 V |
| *a | Component with harness connected (Shift Lock Control ECU) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 (E) - Body ground | Always | Below 1 Ω |
| *a | Component with harness connected (Shift Lock Control ECU) |
Inspect shift lock solenoid
![]() |
Disconnect the shift lock solenoid connector.
![]() |
Measure the resistance according to the value(s) in the table below when the shift lever is moved to each position.
| Tester Connection | Shift Lever Position | Specified Condition |
| 4 (P) - 3 (E2) | P | 10 kΩ or higher |
| 4 (P) - 3 (E2) | Other than P | Below 1 Ω |
| *a | Front view of wire harness connector (to Shift Lock Solenoid) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 (SLS+) - 2 (SLS-) | Always | 112 Ω |
| 2. INSPECT TRANSMISSION CONTROL SWITCH |
![]() |
Measure the resistance between each terminal of the shift lock control unit assembly when the shift lever is moved to each position.
| Tester Connection | Condition | Specified Condition |
| 4 (IG) - 5 (S) | Shift lever in S, "+" or "-" | Below 1 Ω |
| Shift lever not in S, "+" or "-" | 10 kΩ or higher | |
| 3 (SFTU) - 2 (E) | Shift lever held in "+" (Up-shift) | Below 1 Ω |
| Shift lever not held in "+" | 10 kΩ or higher | |
| 1 (SFTD) - 2 (E) | Shift lever held in "-" (Down-shift) | Below 1 Ω |
| Shift lever not held in "-" | 10 kΩ or higher |
| *a | Component without harness connected (Transmission Control Switch) |