ROOM TEMPERATURE SENSOR > REMOVAL |
| 1. REMOVE FRONT DOOR SCUFF PLATE LH |
![]() |
Disengage the 10 claws and remove the front door scuff plate LH.
| 2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH |
![]() |
Remove the clip.
Disengage the 2 clips and remove the cowl side trim sub-assembly LH.
| 3. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH |
![]() |
Disconnect the front door opening trim weatherstrip LH.
| 4. REMOVE INSTRUMENT SIDE PANEL LH |
![]() |
Using a moulding remover, disengage the 4 claws as shown in the illustration.
![]() |
Disengage the 3 guides and remove the instrument side panel LH as shown in the illustration.
| 5. REMOVE FRONT PANEL GARNISH LH |
![]() |
Disengage the 3 claws, 2 clips and 8 guides to remove the front panel garnish LH.
| 6. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY |
![]() |
Disengage the claw and 2 guides to disconnect the hood lock control lever sub-assembly.
| 7. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY |
![]() |
Disengage the 4 clips to remove the lower instrument panel finish panel assembly.
w/ Smart Key System:
Disconnect the connector.
| 8. REMOVE ROOM TEMPERATURE SENSOR (COOLER THERMISTOR) |
![]() |
Disengage the 2 claws as shown in the illustration.
Disconnect the cooler thermistor hose and connector and remove the room temperature sensor (cooler thermistor).