Home › Vehicle Interior › LIGHTING (INT) › ROOM LIGHT

ROOM LIGHT > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ROOM LIGHT ASSEMBLY (w/o Sliding Roof)


    E228309E01
  1. Using a screwdriver with its tip wrapped with protective tape, disengage the 4 claws and remove the No. 1 room light lens.
    Text in Illustration 
    *1
    Protective Tape
    *a
    Front



    E228310E01
  1. Using a screwdriver with its tip wrapped with protective tape, disengage the 4 claws as shown in the illustration and remove the No. 1 room light housing.
    Text in Illustration 
    *1
    Protective Tape
    *a
    Front



    E220648E02
  1. Using a screwdriver, disengage the 4 claws and disconnect the room light switch base from the No. 1 room light housing.
    Text in Illustration 
    *1
    Room Light Switch Base



2. REMOVE SPOT LIGHT ASSEMBLY (w/ Sliding Roof)


    E227560E01
  1. Using a screwdriver with its tip wrapped with protective tape, disengage the 8 claws and remove the 2 spot light lenses.
    Text in Illustration 
    *1
    Protective Tape
    *a
    Front



    E227562E01
  1. Using a screwdriver with its tip wrapped with protective tape and moulding remover, disengage the 2 claws <A>.
    Text in Illustration 
    *1
    Protective Tape
    *2
    Claw <A>
    *3
    Claw <B>
    *4
    Claw <C>
    *a
    Front

  1. Disengage the 2 claws <B> and 2 claws <C>, and disconnect the spot light housing.



    E227564E01
  1. Using a screwdriver, disengage the 8 claws and disconnect the 2 map light sub-assemblies from the spot light housing.
    Text in Illustration 
    *1
    Map Light Sub-assembly