Home › Vehicle Exterior › LIGHTING (EXT) › SIDE TURN SIGNAL LIGHT ASSEMBLY

SIDE TURN SIGNAL LIGHT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure described below is for the LH side.



1. REMOVE OUTER REAR VIEW MIRROR


    B280618E01
  1. Apply protective tape to the areas shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape

  1. Push the upper part of the mirror surface and tilt it.



    B280619E01
  1. Using a moulding remover, disengage the 2 claws at the lower part of the outer rear view mirror as shown in the illustration.
    Text in Illustration 
    *1
    Moulding Remover



    B280621
  1. Disengage the 2 guides as shown in the illustration.



    B280623
  1. Disconnect the 2 connectors and remove the outer rear view mirror.



2. REMOVE OUTER MIRROR COVER


    B280624
  1. Remove the 3 screws.



    B280625
  1. Disengage the clamp.

  1. Disconnect the 2 connectors and remove the mirror actuator.



    B280627
  1. Disengage the 7 claws and remove the outer mirror cover.



3. REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY


    E225012
  1. Disengage the 2 claws.

  1. Disconnect the connector and remove the side turn signal light assembly.