Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY

REAR COMBINATION LIGHT ASSEMBLY > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure described below is for the LH side.



1. INSTALL REAR COMBINATION LIGHT ASSEMBLY
  1. Install the rear combination light assembly with the 4 nuts.

    Torque:
    4.1 N*m{ 42 kgf*cm , 36 in.*lbf }

  1. Engage the clamp.

  1. Connect each connector.



2. INSTALL LUGGAGE COMPARTMENT INNER TRIM COVER


    B280568E01
  1. Install the clip <A>.
    Text in Illustration 
    *1
    Clip <A>
    *2
    Clip <B>

  1. Install the 2 clips <B>.

  1. Engage the fastener and install the luggage compartment inner trim cover LH.



3. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK


    B280638E01
  1. Engage the pin to install the No. 1 luggage compartment trim hook.
    Text in Illustration 
    *1
    Pin



4. INSTALL REAR FLOOR FINISH PLATE


    B280636
  1. Engage the 4 clips and install the rear floor finish plate.

  1. Install the 5 clips.



5. INSTALL BAGGAGE HOLDER NET (w/ Partition Net)
  1. Install the baggage holder net.



6. INSTALL SPARE WHEEL COVER ASSEMBLY
  1. Install the spare wheel cover assembly.



7. INSTALL LUGGAGE COMPARTMENT FLOOR MAT
  1. Install the luggage compartment floor mat.



8. INSTALL REAR BUMPER ASSEMBLY
(Click here)