Home › Vehicle Exterior › LIGHTING (EXT) › LICENSE PLATE LIGHT ASSEMBLY

LICENSE PLATE LIGHT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure described below is for the LH side.



1. REMOVE LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH SUB-ASSEMBLY
(Click here)


2. REMOVE LICENSE PLATE LIGHT ASSEMBLY


    E226675
  1. Disconnect the connector.

  1. Disengage the 2 claws and remove the license plate light assembly.



3. REMOVE LICENSE PLATE LIGHT PACKING


    E226676
  1. Remove the license plate light packing.

    NOTICE:
    Do not reuse the removed packing. Be sure to install a new license plate light packing to prevent water ingress.