OIL AND OIL FILTER > REPLACEMENT |
| 1. DRAIN ENGINE OIL |
Remove the oil filler cap.
Remove the oil pan drain plug and gasket, and drain the engine oil into a container.
Clean the oil pan drain plug and install a new gasket and the oil pan drain plug.
| 2. REMOVE OIL FILTER CAP ASSEMBLY |
![]() |
Connect a hose with an inside diameter of 15 mm (0.591 in.) to the pipe.
| *1 | Pipe |
| *2 | Hose |
![]() |
Remove the oil filter drain plug from the oil filter cap.
![]() |
Install the pipe to the oil filter cap.
| *1 | Valve |
| *2 | Cap |
| *3 | O-ring |
| *4 | Pipe |
![]() |
Check that the oil is drained from the oil filter. Then disconnect the pipe as shown in the illustration and remove the O-ring.
![]() |
Using SST, remove the oil filter cap.
| *1 | Oil Filter Bracket Clip |
![]() |
Remove the oil filter element and O-ring from the oil filter cap.
| *1 | Oil Filter Element |
| *2 | Oil Filter Cap |
| *3 | O-ring |
| 3. INSTALL OIL FILTER CAP ASSEMBLY |
Clean the inside of the oil filter cap, threads and O-ring groove.
![]() |
Apply a small amount of engine oil to a new O-ring and install it to the oil filter cap.
| *1 | Oil Filter Element |
| *2 | Oil Filter Cap |
| *3 | O-ring |
Set a new oil filter element into the oil filter cap.
Remove any dirt or foreign matter from the installation surface of the engine.
Apply a small amount of engine oil to the O-ring again and temporarily install the oil filter cap.
![]() |
Using SST, tighten the oil filter cap.
| *a | No Clearance |
![]() |
Apply a small amount of engine oil to a new O-ring, and install it to the oil filter cap.
| *1 | O-ring |
Install the oil filter drain plug.
| 4. ADD ENGINE OIL |
Add new oil.
| Oil Grade | Oil Viscosity |
| ILSAC multigrade engine oil | 0W-20 |
| Item | Specified Condition |
| Drain and refill (with oil filter change) | 4.4 liters (4.6 US qts, 3.9 Imp. qts) |
| Drain and refill (without oil filter change) | 4.0 liters (4.2 US qts, 3.5 Imp. qts) |
| Dry fill | 5.3 liters (5.6 US qts, 4.7 Imp. qts) |
Install the oil filler cap.
| 5. INSPECT FOR OIL LEAK |
| 6. INSPECT ENGINE OIL LEVEL |
Warm up and stop the engine, and then wait 5 minutes.
Check that the oil level is between the low level mark and full level mark on the engine oil level dipstick.
If the level is low, check for leakage and add oil up to the full level mark.