Home › Drivetrain ยท U660E AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSAXLE SYSTEM

DTC    P062F    Internal Control Module EEPROM Error

for Preparation Click here


DESCRIPTION

The TCM monitors its internal operation and it will set this DTC when it detects an internal malfunction.

DTC No.
DTC Detection Condition
Trouble Area
P062F
TCM internal error (EEPROM)
TCM

MONITOR DESCRIPTION

The TCM monitors its internal operation. If the internal operation is malfunctioning, the TCM illuminates the MIL and sets a DTC.

MONITOR STRATEGY


Related DTCs
P062F: Internal control module EEPROM error
Required sensors/Components (Main)
TCM
Required sensors/Components (Related)
-
Frequency of operation
Once per driving cycle
Duration
11 seconds
MIL operation
Immediate
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


Monitor runs whenever following DTCs not present
None
Time after engine start
10 seconds or more
Battery voltage
8 V or higher
Engine switch
on (IG)
Starter
OFF

TYPICAL MALFUNCTION THRESHOLDS


Permanent fault code data
Mismatch (3 times or more)

INSPECTION PROCEDURE

NOTICE:
  1. After turning engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).
  2. Perform the universal trip to clear permanent DTCs (Click here).

1.READ OUTPUT DTC (DTC P062F)
  1. Connect the Techstream to the DLC3.

  1. Turn the engine switch on (IG).

  1. Turn the Techstream on.

  1. Clear DTCs (Click here).

  1. Turn the engine switch off and turn the Techstream off.

  1. Disconnect the Techstream.

  1. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

  1. Connect the cable to the negative (-) battery terminal.

  1. Connect the Techstream to the DLC3.

  1. Turn the engine switch on (IG).

  1. Turn the Techstream on.

  1. Select the following menu items: Powertrain / ECT / Trouble Codes.

  1. Read DTCs.
    Result 
    Result
    Proceed to
    No output
    A
    P062F
    B



B
REPLACE TCM (Click here)
A

CHECK FOR INTERMITTENT PROBLEMS (Click here)