Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)

DTC    B14B2    Lost Communication with Front Panel LIN

for Preparation Click here


DESCRIPTION

The air conditioning control assembly communicates with the air conditioning amplifier assembly through the LIN communication system.
If the LIN communication system malfunctions, the air conditioning amplifier assembly does not operate even if the air conditioning control assembly is operated.

DTC No.
DTC Detection Condition
Trouble Area
B14B2
Lost communication with the air conditioning control assembly.
  1. Harness or connector between air conditioning control assembly and IG circuit
  2. Harness or connector between air conditioning control assembly and body ground
  3. LIN communication system
  4. Air conditioning control assembly
  5. Air conditioning amplifier assembly

WIRING DIAGRAM


E226613E09


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING CONTROL ASSEMBLY - IG CIRCUIT)
  1. Disconnect the I56 air conditioning control assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    I56-2 (IG+) - Body ground
    Ignition switch off
    Below 1 V
    I56-2 (IG+) - Body ground
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING CONTROL ASSEMBLY - BODY GROUND)
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I56-6 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - AIR CONDITIONING CONTROL ASSEMBLY)
  1. Disconnect the I77 air conditioning amplifier assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I56-9 (LIN1) - I77-37 (LIN1)
    Always
    Below 1 Ω
    I56-9 (LIN1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.REPLACE AIR CONDITIONING CONTROL ASSEMBLY
  1. Replace the air conditioning control assembly (Click here).

    HINT:
    Since the air conditioning control assembly cannot be inspected while it is removed from the vehicle, replace the air conditioning control assembly with a new or a known good one and check that the condition returns to normal.

OK:
Air conditioning control assembly operation returns to normal.


Result:

Result
Proceed to
OK
A
NG (When troubleshooting according to Problem Symptoms Table)
B
NG (When troubleshooting according to the DTC)
C



B
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

C
REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)
A

END (AIR CONDITIONING CONTROL ASSEMBLY WAS DEFECTIVE)