BRAKE PEDAL LOAD SENSING SWITCH > ON-VEHICLE INSPECTION |
| 1. INSPECT BRAKE PEDAL LOAD SENSING SWITCH |
![]() |
Make sure that there is no looseness in the locking part and the connecting part of the connector.
Disconnect the brake pedal load sensing switch connector.
Check both the connector case and the terminal for deformation and corrosion.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 2 (FSW+) - 1 (FSW-) | Switch OFF (Brake pedal depressed) | 950 to 1050 Ω |
| 2 (FSW+) - 1 (FSW-) | Switch ON (Brake pedal released) | 203 to 223 Ω |
| *a | Component without harness connected (Brake Pedal Load Sensing Switch (Brake Pedal Support Assembly)) |