Home › Vehicle Exterior › WIPER / WASHER › WIPER SWITCH

WIPER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY


    E171721E29
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Front Wiper Switch 
    Tester Connection
    Switch Condition
    Specified Condition
    I32-1 (+S) - I32-3 (+1)
    OFF
    Below 1 Ω
    INT
    I32-2 (+B) - I32-3 (+1)
    MIST
    LO
    I32-2 (+B) - I32-4 (+2)
    HI
    Front Washer Switch:
    Tester Connection
    Switch Condition
    Specified Condition
    I31-4 (EW) - I31-7 (WF)
    ON
    Below 1 Ω
    OFF
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Windshield Wiper Switch Assembly)
    If the result is not as specified, replace the windshield wiper switch assembly.