AUDIO AND VISUAL SYSTEM (for Radio Receiver Type) > USB Audio System Recognition/Play Error |

| 1.CHECK USB DEVICE OR "iPod" |
Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.
Check if playable files are present on the USB device or "iPod".
Check if the USB device is a compatible format or "iPod" is a compatible version.
| Condition | Proceed to |
| No playable files exist, or incompatible device format or version | A |
| Playable files exist, and compatible device format or version | B |
|
| ||||
| A | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) |
Disconnect the radio receiver assembly and No. 1 stereo jack adapter assembly connectors.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I146-1 (UPI) - I151-1 (UPO) | Always | Below 1 Ω |
| I146-2 (UDO-) - I151-2 (UPD-) | Always | Below 1 Ω |
| I146-3 (UDO+) - I151-3 (UPD+) | Always | Below 1 Ω |
| I146-4 (UJSG) - I151-4 (UESG) | Always | Below 1 Ω |
| I146-5 (UJSS) - I151-5 (UESS) | Always | Below 1 Ω |
| I146-1 (UPI) - Body ground | Always | 10 kΩ or higher |
| I146-2 (UDO-) - Body ground | Always | 10 kΩ or higher |
| I146-3 (UDO+) - Body ground | Always | 10 kΩ or higher |
| I146-4 (UJSG) - Body ground | Always | 10 kΩ or higher |
| I146-5 (UJSS) - Body ground | Always | 10 kΩ or higher |
| *a | Front view of wire harness connector (to No. 1 Stereo Jack Adapter Assembly) |
| *b | Front view of wire harness connector (to Radio Receiver Assembly) |
|
| ||||
| OK | |
| 3.INSPECT RADIO RECEIVER ASSEMBLY (NO. 1 STEREO JACK ADAPTER ASSEMBLY POWER SOURCE) |
Reconnect the radio receiver assembly connector.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I146-1 (UPI) - I146-4 (UJSG) | Ignition switch ACC | 5 V |
| *a | Front view of wire harness connector (to No. 1 Stereo Jack Adapter Assembly) |
|
| ||||
| OK | |
| 4.FORMAT USB DEVICE OR RESTORE "iPod" AND RECHECK |
Delete all files in the USB device or "iPod" and format/restore it.
Save the data again and check if it can be played on the in-vehicle device.
|
| ||||
| OK | ||
| ||
| 5.REPLACE USB DEVICE OR "iPod" |
Turn the ignition switch off.
Turn the ignition switch to ACC.
Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.
| NEXT | |
| 6.CHECK USB DEVICE OR "iPod" |
Check if a USB device or "iPod" is recognized by the radio receiver assembly, and if information such as track, artist and album names are displayed on the screen.
|
| ||||
| OK | ||
| ||