OUTER REAR VIEW MIRROR > DISASSEMBLY |
| 1. REMOVE OUTER REAR VIEW MIRROR (w/o Retract Mirror) |
![]() |
Apply protective tape to the areas shown in the illustration.
| *1 | Protective Tape |
Push the lower part of the mirror surface and tilt it.
![]() |
Using a moulding remover, disengage the 2 claws at the upper part of the outer rear view mirror as shown in the illustration.
| *1 | Moulding Remover |
![]() |
Disengage the 2 guides and remove the outer rear view mirror as shown in the illustration.
w/ Mirror Heater:
![]() |
Disconnect the 2 connectors and remove the outer rear view mirror.
w/ Mirror Heater and Blind Spot Monitor System:
Disconnect the 2 mirror heater connectors.
Disengage the 2 claws.
![]() |
Using a screwdriver, release the tabs of the blind spot monitor indicator connector to disconnect the connector and remove the outer rear view mirror.
| *1 | Mirror Heater Connector |
| *2 | Blind Spot Monitor Indicator Connector |
| 2. REMOVE OUTER REAR VIEW MIRROR (w/ Retract Mirror) |
![]() |
Apply protective tape to the areas shown in the illustration.
| *1 | Protective Tape |
Push the upper part of the mirror surface and tilt it.
![]() |
Using a moulding remover, disengage the 2 claws at the lower part of the outer rear view mirror as shown in the illustration.
| *1 | Moulding Remover |
![]() |
Disengage the 2 guides as shown in the illustration.
![]() |
Disconnect the 2 connectors and remove the outer rear view mirror.
| 3. REMOVE OUTER MIRROR COVER (w/o Retract Mirror) |
![]() |
Disengage the 8 claws and remove the outer mirror cover.
| 4. REMOVE OUTER MIRROR COVER (w/ Retract Mirror) |
![]() |
Remove the 3 screws.
![]() |
Disengage the clamp.
Disconnect the 2 connectors and remove the mirror actuator.
![]() |
Disengage the 7 claws and remove the outer mirror cover.
| 5. REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY (w/ Retract Mirror) |
![]() |
Disengage the 2 claws.
Disconnect the connector and remove the side turn signal light assembly.