STEERING PAD SWITCH (for 3 Spoke) > INSPECTION |
| 1. INSPECT STEERING PAD SWITCH ASSEMBLY |
Measure the resistance according to the value(s) in the table below.

| Tester Connection | Condition | Specified Condition |
| 1 (HO) - Terminal-A | Always | Below 1 Ω |
| 11 (AU1) - 8 (EAU) | No switch pushed | 95 to 105 kΩ |
| Up switch pushed | Below 2.5 Ω | |
| Down switch pushed | 313 to 345 Ω | |
| Volume+ switch pushed | 950 to 1050 Ω | |
| Volume- switch pushed | 2955 to 3265 Ω | |
| 10 (AU2) - 8 (EAU) | No switch pushed | 95 to 105 kΩ |
| MODE/HOLD switch pushed | Below 2.5 Ω | |
| On hook switch pushed | 313 to 345 Ω | |
| Off hook switch pushed | 950 to 1050 Ω | |
| Voice switch pushed*1 | 2955 to 3265 Ω | |
| 9 (AU3) - 8 (EAU) | No switch pushed | 95 to 105 kΩ |
| Enter switch pushed | Below 2.5 Ω | |
| Back switch pushed | 313 to 345 Ω | |
| Right switch pushed | 950 to 1050 Ω | |
| Left switch pushed | 2955 to 3265 Ω |
| *A | w/ Voice Switch of Steering Pad Switch Assembly | - | - |
| *a | Component without harness connected (Steering Pad Switch Assembly) | *b | Volume+ |
| *c | Volume- | *d | Back |
| *e | MODE/HOLD | *f | Up |
| *g | Down | *h | Left |
| *i | Right | *j | Enter |
| *k | Off hook | *l | On hook |
| *m | Voice | *n | Terminal-A |
Check the illumination.

Connect a battery positive (+) lead to terminal IL+2 and a negative (-) lead to terminal -DP of the steering pad switch assembly connector.
Check that the switch illumination comes on.
| *a | Component without harness connected (Steering Pad Switch Assembly) | - | - |