Home › Vehicle Exterior › MIRROR (EXT) › OUTER REAR VIEW MIRROR GLASS

OUTER REAR VIEW MIRROR GLASS > INSPECTION

for Preparation Click here



1. INSPECT OUTER REAR VIEW MIRROR RH


    B281828E01
  1. Check the outer mirror heater operation (w/ Blind Spot Monitor System).

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      25°C (77°F)
      7.6 to 11.4 Ω

      If the result is not as specified, replace the outer rear view mirror RH.



    B281829E01
  1. Check the outer mirror heater operation (w/o Blind Spot Monitor System).

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      25°C (77°F)
      7.6 to 11.4 Ω

      If the result is not as specified, replace the outer rear view mirror RH.



    B281830E01
  1. Check the outer rear view mirror indicator RH operation (w/ Blind Spot Monitor System).

    1. Connect a positive (+) lead from the battery to terminal 1 (+) and a negative (-) lead to terminal 2 (-).

    2. Check that the outer rear view mirror indicator comes on.

      OK:
      Outer rear view mirror indicator comes on.

      Text in Illustration 
      *a
      Component without harness connected
      (Outer rear view mirror RH)
      If the result is not as specified, replace the outer rear view mirror RH.



2. INSPECT OUTER REAR VIEW MIRROR LH


    B281825E01
  1. Check the outer mirror heater operation (w/ Blind Spot Monitor System).

    1. Measure the resistance according the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      25°C (77°F)
      7.6 to 11.4 Ω

      If the result is not as specified, replace the outer rear view mirror LH.



    B281826E01
  1. Check the outer mirror heater operation (w/o Blind Spot Monitor System).

    1. Measure the resistance according the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      25°C (77°F)
      7.6 to 11.4 Ω

      If the result is not as specified, replace the outer rear view mirror LH.



    B281827E01
  1. Check the outer rear view mirror indicator LH operation.

    1. Connect a positive (+) lead from the battery to terminal 1 (+) and a negative (-) lead to terminal 2 (-).

    2. Check that the outer rear view mirror indicator comes on.

      OK:
      Outer rear view mirror indicator comes on.

      Text in Illustration 
      *a
      Component without harness connected
      (Outer rear view mirror LH)
      If the result is not as specified, replace the outer rear view mirror LH.