SMART KEY SYSTEM (for Start Function) > CUSTOMIZE PARAMETERS |
| 1. CUSTOMIZE SMART KEY SYSTEM (for Start Function) |
Customizing with the Techstream
Connect the Techstream to the DLC3.
Turn the engine switch on (IG).
Turn the Techstream on.
Enter the following menus: Customize Setting / Smart Key/Access or Warning.
Select the setting by referring to the table below.
| Display | Default | Content | Setting | Relevant ECU |
| Ignition Available Area (Entry ignition available area) | All | Function that sets the area that the key must be in before the engine switch can be operated. | Front or All | Certification ECU (smart key ECU assembly) |
| Engine Start Indicator | ON | Function that turns the smart warning light on the combination meter assembly on or off. | OFF or ON | Certification ECU (smart key ECU assembly) |
| Display | Default | Content | Setting | Relevant ECU |
| Key Low Battery Warning (Warn when key battery becomes weak) | ON | Enables or disables the sounding of the buzzer when the transmitter battery is low and the engine switch is turned off after being on (IG) for 20 minutes or more. | OFF or ON | Certification ECU (smart key ECU assembly) |
Customizing with the multi-display (w/ Navigation System (for Navigation Receiver Type) or Audio and Visual System (for Radio and Display Type and with Intuitive Parking Assist System))
Turn the engine switch on (IG).
Enter the following menus: SETUP / Vehicle / Vehicle Customization / Door Lock Settings.
Select the setting by referring to the table below.
| Display | Default | Content | Setting | Relevant ECU |
| Entry and Start System* | On | Function that enables or disables the smart key system. | On or Off | Certification ECU (smart key ECU assembly) |
Entry cancel function (manual operation)
The following functions are disabled when the smart key system is canceled.
When canceling the system through manual operation:
Perform the following procedure to restore the smart key system to the active state from the canceled state.