Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM

LIGHTING SYSTEM > CUSTOMIZE PARAMETERS

for Preparation Click here



1. CUSTOMIZE LIGHTING SYSTEM (INT)
  1. Customizing using the Techstream

    HINT:
    The following items can be customized.

    NOTICE:
    1. When the customer requests a change in a function, first make sure that the function can be customized.
    2. Be sure to make a note of the current settings before customizing.
    3. When troubleshooting a function, first make sure that the function is set to the default setting.


    1. Connect the Techstream to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the Techstream on.

    4. Enter the following menus: Customize Setting / Illuminated Entry.

    5. Select the setting by referring to the table below.

      Illuminated Entry 
      Tester Display
      Default
      Content
      Setting
      Relevant ECU
      Lighting Time
      15 s
      Changes the lighting time after closing all of the doors. (It will fade out immediately in case of turning the ignition switch from off to ACC or ON.)
      7.5 s, 15 s or 30 s
      Main body ECU (Multiplex network body ECU)
      I/L when ACC OFF
      ON
      Lights up the engine switch illumination*1, ignition key cylinder light*2, personal light*3 and rear interior light when the ignition switch is turned from ACC or ON to off.
      ON or OFF
      I/L ON W/Door Key Unlock
      ON
      Lights up the engine switch illumination*1, ignition key cylinder light*2, personal light*3 and rear interior light when doors are unlocked using a mechanical key or door control transmitter.
      ON or OFF
      Room Light when Aprchd
      ON
      Lights up the engine switch illumination*1, ignition key cylinder light*2, personal light*3 and rear interior light when a key enters any actuation area around the doors.
      ON or OFF
      Interior Light Control
      ON
      Lights up the engine switch illumination*1, ignition key cylinder light*2, personal light*3 and rear interior light when the illuminated entry function is operating.
      ON or OFF

      1. *1: w/ Smart Key System
      2. *2: w/o Smart Key System
      3. *3: w/ Sliding Roof

  1. Customizing using the Multi-display (w/ Navigation System (for Navigation Receiver Type) or w/ Audio and Visual System (for Radio and Display Type with Intuitive Parking Assist System))

    1. Turn the ignition switch to ON.

    2. Enter the following menus: Setup / Vehicle / Vehicle Customization / Light Settings

    3. Select the setting by referring to the table below:

      Display
      Default
      Content
      Setting
      Relevant ECU
      Interior Lights Off Timer
      15 sec.
      Changes the lighting time after closing all of the doors. (It will fade out immediately in case of turning the ignition switch from off to ACC or ON.)
      Off, 7.5 sec., 15 sec., or 30 sec.
      Main body ECU (Multiplex network body ECU)