Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

BLIND SPOT MONITOR SYSTEM > SYSTEM DESCRIPTION

for Preparation Click here



GENERAL
  1. The blind spot monitor is a system that assists the driver in making the decision to change lanes. The system uses quasi-millimeter wave radar to detect vehicles that are traveling in an adjacent lane in the area that is not reflected in the outer rear view mirror assembly. The system advises the driver of the existence of a vehicle by illuminating the blind spot monitor indicator on the outer rear view mirror assembly.
  2. If the turn signal is operated while the blind spot monitor indicator on an outer rear view mirror assembly is illuminated, the indicator starts blinking to give additional warning to the driver.

FUNCTION OF COMPONENTS

Component
Function
Blind Spot Monitor Sensor
  1. Consists of a 24 GHz radar module and an integrated processing module.
  2. Illuminates the outer rear view mirror indicator on the outer rear view mirror assembly when a vehicle is present in the blind spot area.
  3. Changes the outer rear view mirror indicator on the outer rear view mirror assembly from illuminated to blinking when a turn signal is received from the combination meter assembly.
Outer Rear View Mirror Indicator
Turns on or blinks the indicator based on a signal from the blind spot monitor sensor.
Blind Spot Monitor Main Switch (Warning Canceling Switch Assembly)
Turns the blind spot monitor on or off.
Combination Meter Assembly
  1. Sends a turn signal state signal from the headlight dimmer switch assembly (turn signal light switch) to the blind spot monitor sensor via CAN communication.
  2. If the blind spot monitor detects a malfunction while it is operating, it turns on a warning light.
Main Body ECU
(Multiplex Network Body ECU)
Sends the destination information to the blind spot monitor sensor via CAN communication.
Brake Actuator Assembly
(Skid Control ECU)
Transmits a vehicle speed signal to the blind spot monitor sensor via CAN communication.
ECM
Sends shift position signal (R) and HV flag to the blind spot monitor sensor via CAN communication.
Steering Sensor
Detects the angle of the steering wheel and sends the resulting signals to the blind spot monitor sensor via CAN communication.

OPERATION DESCRIPTION
  1. Operation conditions of the blind spot monitor system

    1. The blind spot monitor main switch (warning canceling switch assembly) is on.
    2. Vehicle speed is more than approximately 40 km/h (25 mph).

  2. Conditions in which a sensor can detect a vehicle
    The blind spot monitor system indicates detection of a vehicle in the detection area when either condition is met:

    1. When a vehicle is detected in an adjacent lane overtaking this vehicle.

    2. When another vehicle is detected entering the detection area because it changed lanes.



  3. E211813E01
  4. Detection area

    1. Vehicles in the following areas can be detected:
      *a
      Within approx. 3.5 m (11.49 ft) from the side of the vehicle
      *b
      Within approx. 3 m (9.85 ft) behind the rear bumper
      *c
      Within approx. 1 m (3.29 ft) forward of the rear bumper


OPERATION OF OUTER REAR VIEW MIRROR INDICATOR ON OUTER REAR VIEW MIRROR ASSEMBLY


    E224408E01
  1. The outer rear view mirror indicator on each outer rear view mirror assembly operates as follows:

    1. When the blind spot monitor main switch (warning canceling switch assembly) is turned on, the outer rear view mirror indicator on each outer rear view mirror assembly illuminates for 3 seconds (initial check).
    2. While the system is operating, when a sensor detects a vehicle in the blind spot area, the outer rear view mirror indicator on the outer rear view mirror assembly illuminates.
    3. While the system is detecting a vehicle in the detection area and the indicator is illuminated, if the turn signal is turned on, the indicator starts blinking.