NAVIGATION ECU > INSTALLATION |
| 1. INSTALL EXTENSION MODULE |
Connect the connector to install the extension module.
Connect the 3 connectors to install the navigation wire.
| 2. INSTALL AIR CONDITIONING CONTROL ASSEMBLY |
![]() |
Engage the guide and 4 clips to install the air conditioning control assembly as shown in the illustration.
| 3. INSTALL NO. 1 RADIO BRACKET |
w/o Navigation System:
Install the No. 1 radio bracket with the 5 screws.
w/ Navigation System:
Install the No. 1 radio bracket with the 7 screws.
| 4. INSTALL NO. 2 RADIO BRACKET |
w/o Navigation System:
Install the No. 2 radio bracket with the 5 screws.
w/ Navigation System:
Install the No. 2 radio bracket with the 7 screws.
| 5. INSTALL RADIO RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY |
Connect each connector.
Engage the 8 clips to the vehicle body to temporarily install the radio receiver assembly with air conditioning control assembly.
Install the radio receiver assembly with air conditioning control assembly with the 4 bolts.
| 6. INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY |
![]() |
Engage the 6 clips to install the No. 2 instrument panel register assembly.
| 7. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY |
Connect the connector.
Engage the clamp.
![]() |
Engage the 6 clips and 7 claws to install the center instrument cluster finish panel assembly.
| 8. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY |
Connect each connector.
Engage the 4 clips and guide.
Install the upper console panel sub-assembly with the 2 screws <C> or <D>.
| 9. INSTALL BOX BOTTOM MAT |
Install the box bottom mat.
| 10. INSTALL REAR CONSOLE BOX ASSEMBLY |