NAVIGATION ECU > REMOVAL |
| 1. REMOVE REAR CONSOLE BOX ASSEMBLY |
| 2. REMOVE BOX BOTTOM MAT |
![]() |
Remove the box bottom mat.
| 3. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY |
![]() |
Remove the 2 screws <C> or <D>.
![]() |
Disengage the 4 clips and guide as shown in the illustration.
Disconnect each connector to remove the upper console panel sub-assembly.
| 4. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY |
![]() |
Using a moulding remover, disengage the 2 claws and 2 clips as shown in the illustration.
![]() |
Using a moulding remover, disengage the 2 claws and 2 clips as shown in the illustration.
![]() |
Disengage the 3 claws and 2 clips as shown in the illustration.
![]() |
Disengage the clamp.
Disconnect the connector to remove the center instrument cluster finish panel assembly.
| 5. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY |
![]() |
Pull the No. 2 instrument panel register assembly in the direction indicated by the arrow to disengage the 6 clips to remove the No. 2 instrument panel register assembly.
| 6. REMOVE RADIO RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY |
![]() |
Apply protective tape to the area shown in the illustration.
| *1 | Protective Tape |
![]() |
Remove the 4 bolts.
![]() |
Pull the radio receiver assembly with air conditioning control assembly toward the rear of the vehicle and disengage the 8 clips.
Disconnect each connector and remove the radio receiver assembly with air conditioning control assembly.
| 7. REMOVE NO. 1 RADIO BRACKET |
w/o Navigation System:
![]() |
Remove the 5 screws and No. 1 radio bracket.
w/ Navigation System:
![]() |
Remove the 7 screws and No. 1 radio bracket.
| 8. REMOVE NO. 2 RADIO BRACKET |
w/o Navigation System:
![]() |
Remove the 5 screws and No. 2 radio bracket.
w/ Navigation System:
![]() |
Remove the 7 screws and No. 2 radio bracket.
| 9. REMOVE AIR CONDITIONING CONTROL ASSEMBLY |
![]() |
Disengage the 4 clips and guide, and remove the air conditioning control assembly as shown in the illustration.
| 10. REMOVE EXTENSION MODULE |
![]() |
Disconnect the 3 connectors to remove the navigation wire.
![]() |
Disconnect the connector to remove the extension module.