Home › Vehicle Exterior › WIPER / WASHER › WIPER SWITCH

WIPER SWITCH > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY


  1. Check the front wiper intermittent operation (w/ Intermittent timing adjustment).



      E171721E32
    1. Connect a voltmeter positive (+) lead to terminal I32-3 (+1) and a negative (-) lead to terminal I31-4 (EW).
      Text in Illustration 
      *a
      Component with harness connected
      (Windshield Wiper Switch Assembly)

    2. Turn the wiper switch to the INT position.



    3. Operate the intermittent wiper relay and check the voltage between terminals I32-3 (+1) and I31-4 (EW).

      OK:
      Voltage changes as shown in the illustration.



      E136493E03

      If the result is not as specified, replace the windshield wiper switch assembly.



  1. Check the front wiper intermittent operation (w/o Intermittent timing adjustment).



      E171721E32
    1. Connect a voltmeter positive (+) lead to terminal I32-3 (+1) and a negative (-) lead to terminal I31-4 (EW).
      Text in Illustration 
      *a
      Component with harness connected
      (Windshield Wiper Switch Assembly)

    2. Turn the wiper switch to the INT position.



    3. Operate the intermittent wiper relay and check the voltage between terminals I32-3 (+1) and I31-4 (EW).

      OK:
      Voltage changes as shown in the illustration.



      E226601E01

      If the result is not as specified, replace the windshield wiper switch assembly.



  1. Check the front washer operation.



      E171721E32
    1. Connect a voltmeter positive (+) lead to terminal I32-3 (+1) and a negative (-) lead to terminal I31-4 (EW).
      Text in Illustration 
      *a
      Component with harness connected
      (Windshield Wiper Switch Assembly)

    2. Turn the ignition switch to ON.



    3. Turn the washer switch on and off, and check the voltage between terminals I32-3 (+1) and I31-4 (EW).

      OK:
      Voltage changes as shown in the following illustration.



      E226602E02

      If the result is not as specified, replace the windshield wiper switch assembly.