Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM

PARKING ASSIST MONITOR SYSTEM > Guide Lines are Displayed with Vehicle Center Line

for Preparation Click here


DESCRIPTION

The rear television camera assembly can create parking guide lines. Because this function is not necessary on vehicles with the parking assist monitor system, the guide line creation function of the rear television camera assembly is disabled.

WIRING DIAGRAM


E224386E01


INSPECTION PROCEDURE

1.CHECK SCREEN MODE


    E226200E01
  1. Check the back guide monitor screen.

    Result:
    Result
    Proceed to
    Guide lines are displayed with vehicle center line.
    A
    Guide lines are displayed without vehicle center line.
    B

    Text in Illustration 
    *a
    Vehicle Center Line



B
USE SIMULATION METHOD TO CHECK (A WIRE MAY BE OPEN) (Click here)
A


2.CHECK HARNESS AND CONNECTOR (REAR TELEVISION CAMERA ASSEMBLY - BODY GROUND)


    E226197E01
  1. Disconnect the T6 connector from the rear television camera assembly.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      T6-1 (CURT) - Body ground
      Always
      Below 1 Ω

      Text in Illustration 
      *a
      Front view of wire harness connector
      (to Rear Television Camera Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE REAR TELEVISION CAMERA ASSEMBLY (Click here)