INTEGRATION RELAY > ON-VEHICLE INSPECTION |
| 1. INSPECT ENGINE ROOM JUNCTION BLOCK ASSEMBLY (SIGNAL READING CHECK) |
Signal reading check
Turn the ignition switch to ON.
![]() |
Connect the positive (+) terminal of a voltmeter to the engine room junction block assembly and the negative (-) terminal to the body ground.
| *a | Component with harness connected (Engine Room Junction Block Assembly) |
| *b | Diagnosis Terminal |
Using the illustration below as a reference, determine whether any channels are malfunctioning based on the observed signal reading.

| Channel | Connected Electrical Load | |||
| for 2AR-FE | for 2GR-FE | |||
| w/ Front Fog Light | w/ Mirror Heater | w/o Mirror Heater | ||
| ch0 | Radiator fan motor | - | - | Magnetic clutch |
| ch1 | Condenser fan motor | - | - | - |
| ch2 | Mirror heater | Mirror heater | - | Mirror heater |
| ch3 | - | - | - | - |
| ch4 | - | - | - | - |
| ch5 | - | Rear window defogger wire | Rear window defogger wire | - |
| ch6 | Front fog lights | Condenser fan motor | Condenser fan motor | Front fog lights |
| ch7 | Rear window defogger wire | Radiator fan motor | Radiator fan motor | Rear window defogger wire |
| ch8 | High beam headlight LH | |||
| ch9 | High beam headlight RH | |||
| 2. INSPECT ENGINE ROOM JUNCTION BLOCK ASSEMBLY (RESULTS OF SIGNAL READING CHECK) |
Results of signal reading check
Depending on the signal reading, perform troubleshooting according the table below.
| Output Signal Reading | Repair Method |
| Normal | Continue troubleshooting for each system. |
| The unit is malfunctioning. | Replace the engine room junction block. |
| A malfunction in a channel (ch0 to ch9) |
|
![]() |
If no signal readings are output, perform troubleshooting according to the following troubleshooting procedure.
| Tester Connection | Switch Condition | Specified Condition |
| 1F-15 (IGN) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Component without engine room junction block assembly (Engine Room Relay Block and Junction Block Assembly) |