Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR MAIN SWITCH

BLIND SPOT MONITOR MAIN SWITCH > INSPECTION

for Preparation Click here



1. INSPECT BLIND SPOT MONITOR MAIN SWITCH (WARNING CANCELING SWITCH ASSEMBLY)


    E224422E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    11 (B) - 8 (D)
    Blind spot monitor main switch assembly on (not protruding)
    Below 1 Ω
    11 (B) - 8 (D)
    Blind spot monitor main switch assembly off (protruding)
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Blind Spot Monitor Main Switch (Warning Canceling Switch Assembly))
    If the result is not as specified, replace the blind spot monitor main switch (warning canceling switch assembly).



  1. Check that the switch illuminates.



      E224422E03
    1. Apply battery voltage to the blind spot monitor main switch (warning canceling switch assembly) and check that the switch illuminates.

      OK:
      Connection
      Specified Condition
      Battery positive (+) → Terminal 10 (ILL+)
      Battery negative (-) → Terminal 9 (ILL-)
      Illuminates

      Text in Illustration 
      *a
      Component without harness connected
      (Blind Spot Monitor Main Switch (Warning Canceling Switch Assembly))
      If the result is not as specified, replace the blind spot monitor main switch (warning canceling switch assembly).



  1. Check that the switch indicator.



      E224422E04
    1. Apply battery voltage to the blind spot monitor main switch assembly and check operation of the switch, as shown in the table below.

      OK:
      Connection
      Switch Condition
      Specified Condition
      Battery positive (+) → Terminal 11 (B)
      Battery negative (-) → Terminal 12 (E)
      Blind spot monitor main switch assembly on (not protruding)
      Indicator Illuminates

      Text in Illustration 
      *a
      Component without harness connected
      (Blind Spot Monitor Main Switch (Warning Canceling Switch Assembly))
      If the result is not as specified, replace the back sonar or blind spot monitor main switch (warning canceling switch assembly).