Home › Engine / Hybrid System · CRUISE CONTROL › CRUISE CONTROL MAIN SWITCH

CRUISE CONTROL MAIN SWITCH > INSPECTION

for Preparation Click here



1. INSPECT CRUISE CONTROL SWITCH


  1. Measure the resistance according to the value(s) in the table below.


    E144930E19


    Standard Resistance:

    Tester Connection
    Switch Condition
    Specified Condition
    1 - 3
    Cruise control switch (ON-OFF button) released
    1 MΩ or higher
    Cruise control switch (ON-OFF button) pushed
    Below 2.5 Ω
    +/RES switch ON
    235 to 245 Ω
    -/SET switch ON
    617 to 643 Ω
    CANCEL switch ON
    1509 to 1571 Ω


    Text in Illustration 
    *1
    Cruise Control Switch (ON-OFF button)
    -
    -
    *a
    Component without harness connected
    (Cruise Control Switch)
    *b
    ON-OFF
    *c
    +/RES
    *d
    -/SET
    *e
    CANCEL
    -
    -