OUTLINE
Combination Meter Assembly
An Optitron type combination meter assembly is provided.
The combination meter assembly has a built-in meter ECU, 2 LCD displays, a multi-information display and a buzzer.
| *A | Except Sportivo SX6/Sportivo ZR6 Grade | *B | Sportivo SX6/Sportivo ZR6 Grade |
| *1 | Rheostat Switch | *2 | LCD |
| *3 | Multi-information Display | *4 | ODO/TRIP Switch |
| *1 | Rheostat Switch | *2 | LCD |
| *3 | Multi-information Display | *4 | ODO/TRIP Switch |
MAIN FEATURES
Combination Meter Assembly
An illumination control which allows for anticipation of a pleasant drive is used. If the ignition switch is turned to ON, the illumination control operates as follows:
When the ignition switch is turned to ON, the opening display appears on the multi-information display.
The following illuminations fade in: the speedometer, tachometer, fuel gauge, fuel consumption meter needle indicator, 2 LCD displays and meter panel illumination.
When the ignition switch is turned off, all the illuminations fade out. During this period, the multi-information display shows the Eco drive level for 3 seconds.
|
Ignition switch off to ON |
|
Ignition switch ON to off |
Fuel Consumption Gauge
A needle indicator type average fuel consumption gauge is provided on the combination meter assembly. The needle indicator indicates the value in accordance with the average fuel consumption value displayed on the multi-information display.
An instantaneous fuel consumption gauge is provided. This gauge is a segment type indicator and is arranged outside the average fuel consumption gauge. This arrangement enables the driver to check the average and instantaneous fuel consumption simultaneously, assisting eco-friendly driving.
| *1 | Average Fuel Consumption Gauge | *2 | Instantaneous Fuel Consumption Gauge |
LCD
2 LCDs are provided in the combination meter assembly. Each display shows the following information.
| Item | Outline |
|---|---|
| LCD (Tachometer Side) | ·
The following information items are always displayed. ·
Shift Position Indicator ·
Engine Coolant Temperature Gauge (segment type display) ·
Ambient Temperature ·
When the rheostat switch is pressed, the engine coolant temperature gauge will change into meter illumination adjustment mode. The meter illumination can be switched between 6 levels. |
| LCD (Fuel Gauge Side) | ·
The following information items can be displayed. The item shown can change by pressing the ODO/TRIP switch. ·
Odometer ·
Trip Meter A ·
Trip Meter B |
Multi-information Display
The multi-information display shows the following information.
| Mode | Outline |
|---|---|
|
*: Models with TOYOTA parking assist-sensor system |
|
| Cruise Information | ·
The item shown can be changed by pushing the DISP switch in the steering pad switch assembly. ·
In cruise information mode, the following information can be displayed: ·
Cruising Range and Average Fuel Consumption ·
Average Vehicle Speed and Elapsed Time ·
Eco Drive Level ·
Settings ·
Blank Screen |
| Clearance Sonar Display* | The obstruction detection state of the clearance sonars is displayed. |
| Warning | The warning display will interrupt the multi-information display immediately when a warning occurs. |
| Customization | The following display, performance or illumination of the combination meter assembly can be customized: ·
Language ·
Eco Driving Indicator Light and instantaneous fuel consumption gauge |
PRECAUTION
Ignition Switch Expressions
The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.
| Expression | Ignition Switch
(Position) |
Engine Switch
(Condition) |
|---|---|---|
| Ignition Switch off | LOCK | Off (Lock) |
| Ignition Switch ACC | ACC | On (ACC) |
| Ignition Switch ON | ON | On (IG) |
| Engine Start | START | On (Start) |