OUTLINE
The automatic air conditioning system uses left and right independent temperature control and neural network control to enhance comfort.
SPECIFICATION
Performance
| Heater | Heater Output | W | 5850 |
| Air Flow Volume | m3/h | 380 | |
| Power Consumption | W | 220 | |
| Cooler | Cooling Capacity | W | 6100 |
| Air Flow Volume | m3/h | 530 | |
| Power Consumption | W | 260 |
Ventilation and Heater Core
| Heater Radiator Unit Sub-assembly | Type | Straight Flow Aluminum (SFA) -II | |
| Size W x H x L | mm (in.) | 201.5 x 150 x 27 (7.9 x 5.9 x 1.1) | |
| Fin Pitch | mm (in.) | 1.5 (0.06) | |
| Blower with Fan Motor Sub-assembly | Motor Type | BMM - K70 | |
| Fan Type | Semi Sirocco | ||
| Fan Size (Dia. x H) | mm (in.) | 165 x 70 (6.5 x 2.8) | |
Air Conditioning
| Cooler Condenser Assembly | Type | Multi-Flow (MF)-IV | |
| Size W x H x L | mm (in.) | 720 x 370.2 x 16
(28.3 x 14.6 x 0.6) |
|
| Fin Pitch | mm (in.) | 3.15 (0.12) | |
| Cooler Compressor Assembly | Type | TSB17C | |
| Pulley | Steel with Magnetic Clutch | ||
| Oil Volume | cc | 100 to 115 | |
| Refrigerant | Type | HFC 134a | |
| Charge Volume | g | 450 to 550 | |
| Evaporator | Type | Revolutionary super-slim Structure (RS) | |
| Size W x H x L | mm (in.) | 266.3 x 251 x 38 (10.5 x 9.9 x 1.5) | |
| Fin Pitch | mm (in.) | 2.6 (0.10) | |
MAIN FEATURES
The air conditioning system has the following features:
| High Performance | ·
Using the following features of the compressor (continuously variable capacity compressor), high cooling performance and a quiet cabin have been achieved: ·
Neural network control is used so passengers can finely control the air conditioning for maximum comfort. ·
The blower control has 7 steps to allow precise control. ·
Magnetic Flux Sensor Type Air Conditioning Mass Flow Sensor ·
Oil Separator ·
Variable Suction Side Throttle ·
Solenoid Valve with Built-in Crank Chamber to Suction Passage (CS) Valve |
| Lightweight | ·
An air conditioning harness assembly with a built-in IC is used in a lightweight wire harness design to allow a reduced number of wires. ·
The use of this connector means that pulse pattern type servo motors are used. |
| Others | The following parts are used to ensure high cooling performance while realizing a compact and lightweight construction.
·
Semi-center Location Air Conditioning Unit ·
Revolutionary Super-slim Structure (RS) Evaporator ·
Straight Flow Aluminum (SFA)-II Heater Radiator Sub-assembly ·
Multi-Flow (MF)-IV Sub-cool Condenser |