CONSTRUCTION
The TCM and ECM use these switches to detect the shift lever position.
The park/neutral position switch sends the P, R, N and D position signals to both the ECM and TCM. The ECM transmits signals to the combination meter assembly for the shift position indicator lights (P, R, N and D) in response to the signals received from the switch.
The transmission control switch is installed inside the lower shift lever assembly to inform the ECM of the shift lever position.
The transmission shift switch assembly is built into the steering wheel assembly and informs the ECM of the driver's "-" or "+" shift operation.*
Switch terminal S is used to detect whether the shift lever is in D or S, and terminals SFTU and SFTD are used to detect the operation of the shift lever (if it is moved to the "+" or "-") when S mode is selected. By transmitting signals to the ECM, the transmission control switch turns on both the shift indicator light and the S mode indicator light when the shift lever is moved to S, and indicates the selected range through shift indicator light.
*: Models with shift paddle switch