Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM
NM2030EQ _59 Vehicle Exterior _014326 LIGHTING (EXT) _0072949 LIGHTING SYSTEM CO CONTROL F

LIGHTING (EXT)  LIGHTING SYSTEM  CONTROL  HIGH INTENSITY DISCHARGE (HID) HEADLIGHT  


FUNCTION OF MAIN COMPONENTS


a.

High Intensity Discharge (HID) Headlight System

Component Function
Main Body ECU (Multiplex Network Body ECU) Receives the light control signal and transmits a signal to the headlight dimmer relay.
Headlight Dimmer Switch Assembly Light Control Switch Outputs a light control signal and transmits it to the main body ECU (multiplex network body ECU).
Headlight Assembly Discharge Bulb The discharge bulb light shines ahead over a broader area and further forward, increasing the area visible to the driver.
Light Control ECU Transforms battery voltage to a high voltage of up to 30000 V and applies it to the discharge bulbs in order to illuminate them.
Headlight Dimmer Relay Supplies power to the light control ECUs.



FAIL-SAFE


a.

The light control ECU executes the fail-safe functions listed below in accordance with the problem that has been detected.

Problem Outline
Abnormal Input Voltage If the voltage that is input to the light control ECU deviates from the normal operating voltage (9 to 16 V), the light control ECU stops illuminating the headlight. It resumes illuminating the headlight once the voltage reverts to the normal operating voltage. However, if the input voltage decreases after the headlights have illuminated, the headlights will remain illuminated until the input voltage becomes insufficient to light the bulbs.
Abnormal Output (Open Circuit or Short Circuit) If an abnormal condition (open or short) occurs in the voltage that is output by the light control ECU, the light control ECU stops illuminating the headlight and will maintain this state until the power is reinstated. Power is reinstated by turning the light control switch from off to on.
Bulb Open Circuit If a bulb is not inserted in its socket, the light control ECU stops generating high voltage until the bulb is inserted correctly and the power is reinstated. Power is reinstated by turning the light control switch from off to on or turning the ignition switch from off to ON.