FUNCTION OF MAIN COMPONENTS
Automatic Headlight Beam Level Control System
| Component | Function | |
|---|---|---|
| Headlight Swivel ECU Assembly | ·
Detects changes of vehicle movement based on the rear height control sensor sub-assembly and vehicle speed signal. ·
Outputs control signals to the headlight leveling motors based on the detected value. ·
Provides initial set control and a fail-safe function. |
|
| Headlight Dimmer Switch Assembly | Light Control Switch | Outputs a light control signal and transmits it to the main body ECU (multiplex network body ECU). |
| Headlight Assembly (LH, RH) | Headlight Leveling Motor (LH, RH) | ·
Based on the signals received from the headlight swivel ECU assembly, each headlight leveling motor moves the projector unit in its headlight to vary its angle. ·
Each headlight leveling motor uses a stepper motor to precisely regulate the angle of the projector unit. |
| Main Body ECU (Multiplex Network Body ECU) | Receives a light control signal and transmits it to the headlight swivel ECU assembly. | |
| Rear Height Control Sensor Sub-assembly | Detects vehicle movement and transmits a signal to the headlight leveling ECU assembly. | |
| Combination Meter Assembly | AFS OFF Indicator Light | Flashes to inform the driver when the headlight swivel ECU assembly detects malfunctions in this system. |
FUNCTION
The automatic headlight beam level control system mainly consists of the headlight swivel ECU assembly, rear height control sensor sub-assembly and 2 headlight leveling motors. The headlight leveling ECU assembly controls the system.
The headlight swivel ECU assembly detects the movement of the suspension from the rear height control sensor sub-assembly and the vehicle speed from the combination meter assembly.
The headlight swivel ECU assembly then controls the headlight leveling motor based on this information, in order to change the low beam angle.
When the headlight swivel ECU assembly detects that the vehicle is stopped and the ignition switch is ON, it executes the initial setting of the stepper motors.
FAIL-SAFE
If an abnormal condition such as those listed below is detected, the headlight swivel ECU assembly operates in fail-safe mode.
The headlight swivel ECU assembly flashes the AFS OFF indicator light in the combination meter assembly when an abnormality in the rear height control sensor sub-assembly is detected.
| Trouble Area | Condition | Fail-safe Operation |
|---|---|---|
| Rear Height Control Sensor Sub-assembly | Signal level abnormality | Holds the beam at the position of the headlight when abnormality is detected. |
| Headlight Leveling Motor | Open or short circuit | |
| Combination Meter Assembly
- Vehicle Speed Signal |
Vehicle speed signal pulse abnormality | |
| Headlight Swivel ECU Assembly | Voltage abnormality |
DIAGNOSIS
When the headlight swivel ECU assembly detects a malfunction in the automatic headlight beam level control system, Diagnostic Trouble Codes (DTCs) are stored in memory.
The DTCs can be read using the intelligent tester. For details, refer to the Repair Manual.