Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM
NM2030EQ _59 Vehicle Exterior _014325 WIPER / WASHER _0072948 WIPER AND WASHER SYSTEM DE DETAILS F

WIPER / WASHER  WIPER AND WASHER SYSTEM  DETAILS  RAIN SENSOR  


CONSTRUCTION


a.

The rain sensor consists of a Light Emitting Diode (LED) that emits infrared rays, a photo diode that can receive those rays, a lens and rain sensor tape.


b.

In order to enhance the responsiveness of the day/night control and the tunnel control, the 2 built-in light sensors have been provided.

Y109489
2.927,0.875 2.375,0.292 2.375,0.292 2.125,0.292 true 2.917,1.188 2.052,1.719 2.052,1.719 1.813,1.719 true 2.781,1.646 2.135,2.396 2.135,2.396 1.885,2.396 true 4.698,1.656 5.344,2.417 5.344,2.417 5.583,2.417 true 4.833,1.646 5.708,0.885 5.708,0.885 5.958,0.885 true 4.115,1.646 3.469,2.406 3.469,2.406 3.229,2.406 true 1.938,0.198 2.094,0.375 0.156,0.177 10 false *1 1.635,1.604 1.792,1.781 0.156,0.177 10 false *2 1.719,2.302 1.875,2.479 0.156,0.177 10 false *3 5.99,0.802 6.146,0.979 0.156,0.177 10 false *4 3.052,2.313 3.208,2.49 0.156,0.177 10 false *5 5.604,2.302 5.76,2.479 0.156,0.177 10 false *6
*1 Rain Sensor Tape *2 Lens
*3 Photo Diode *4 LED
*5 Photo Diode for Forward Detection (Light Sensor) *6 Photo Diode for Upward Detection (Light Sensor)



c.

If no raindrops are present in the detection area, the infrared rays emitted by the LED are all reflected from the outer surface of the windshield glass and are received by the photo diode.


d.

If raindrops are present in the detection area, a portion of the emitted infrared rays will penetrate the windshield glass due to the change in the difference of the index of refraction between the glass and the area outside the windshield (difference between air and water). The ability of the windshield glass to reflect all light back inside changes due to the presence of raindrops. This change of internal reflection due to the presence of water reduces the amount of infrared rays that are received by the photo diode. The amount of this reduction is then used to determine the amount of raindrops. This function then selects intermittent, low, or high wiper operation in order to operate the wipers at an optimal speed and timing.


e.

By using 2 light sensors, the sensitivity to detect night has been improved. In addition, when a tunnel is detected, the responsiveness around the entrance/exit of the tunnel has been improved.

Y109490
1.188,1.125 0.625,0.552 0.625,0.552 0.375,0.552 true 1.177,1.99 0.771,2.542 0.771,2.542 0.531,2.542 true 2.74,1.99 3.115,2.563 3.115,2.563 3.365,2.563 true 2.448,1.417 3.24,0.635 3.24,0.635 3.49,0.635 true 4.927,0.844 5.448,0.323 5.448,0.323 5.698,0.323 true 5.208,1.031 5.646,0.583 5.646,0.583 5.885,0.583 true 5.802,1.396 6.49,0.677 6.49,0.677 6.74,0.677 true 6.115,2 6.448,2.531 6.448,2.531 6.698,2.531 true 4.552,2 4.167,2.573 4.167,2.573 3.927,2.573 true 0.208,0.469 0.365,0.646 0.156,0.177 10 false *1 0.354,2.458 0.51,2.635 0.156,0.177 10 false *2 3.521,0.552 3.677,0.729 0.156,0.177 10 false *a 3.385,2.49 3.542,2.667 0.156,0.177 10 false *3 5.719,0.24 5.875,0.417 0.156,0.177 10 false *a 5.917,0.51 6.073,0.688 0.156,0.177 10 false *b 6.76,0.604 6.917,0.781 0.156,0.177 10 false *a 6.719,2.469 6.875,2.646 0.156,0.177 10 false *3 3.771,2.49 3.927,2.667 0.156,0.177 10 false *2
*1 Windshield Glass *2 Photo Diode
*3 LED - -
*a Infrared Ray *b Raindrop