Home › Engine / Hybrid System › 2GR-FE ENGINE CONTROL › CAMSHAFT OIL CONTROL VALVE
RM2030EQ _51 Engine / Hybrid System _014634 2GR-FE ENGINE CONTROL _0074395 CAMSHAFT OIL CONTROL VALVE G

2GR-FE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE  INSPECTION  


PROCEDURE

Hide 1.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Specified Condition
1 - 2 6.9 to 7.9 Ω at 20°C (68°F)


If the result is not as specified, replace the oil control valve assembly.


b.
A095391
1.083,0.188 1.01,0.188 1.01,0.188 0.844,1.052 false 2.531,1.688 2.26,1.604 false 1.125,0.115 1.948,0.271 0.823,0.156 10 *1 2.042,1.531 2.24,1.76 0.198,0.229 10 *2
*1 Spool Valve
*2 Battery


Check the operation.

i.

Connect a battery positive (+) lead to terminal 1 and negative (-) lead to terminal 2, and check the movement of the spool valve.

OK:
Condition Specified Condition
Battery voltage is applied Valve moves in black arrow direction shown in illustration
Battery voltage is not applied Valve moves in white arrow direction shown in illustration


If the result is not as specified, replace the oil control valve.

NOTICE:

Accumulation of foreign matter can cause minor pressure leaks. Minor pressure leaks in the intake side oil control valve will cause the intake camshaft to advance. Minor pressure leaks in the exhaust side oil control valve will cause the exhaust camshaft to retard. The inappropriate camshaft timing that results from these leaks will cause a DTC to be set.