Home › Engine / Hybrid System › 2GR-FE ENGINE CONTROL › CAMSHAFT OIL CONTROL VALVE
RM2030EQ _51 Engine / Hybrid System _014634 2GR-FE ENGINE CONTROL _0074395 CAMSHAFT OIL CONTROL VALVE G

2GR-FE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

a.

Connect the intelligent tester to the DLC3.


b.

Start the engine.


c.

Turn the intelligent tester on.


d.

Turn the A/C switch on.


e.

Inspect the oil control valve assembly (for intake camshaft).

i.

Enter the following menus: Powertrain / Engine / Active Test / Control the VVT Linear (Bank 1).

Powertrain > Engine > Active Test
Tester Display
Control the VVT Linear (Bank1)
50004 234 32

ii.

Check the engine speed while operating the camshaft timing oil control valve assembly (for intake camshaft) using the intelligent tester.

Standard Condition:
Intelligent Tester Operation Engine Condition
0% Normal engine speed
100% Engine idles roughly or stalls


If the operation is not as specified, check the oil control valve assembly, wire harness and ECM.


iii.

Enter the following menus: Powertrain / Engine / Active Test / Control the VVT Linear (Bank 2).

Powertrain > Engine > Active Test
Tester Display
Control the VVT Linear (Bank2)
50004 234 31

iv.

Check the engine speed while operating the camshaft timing oil control valve assembly (for intake camshaft) using the intelligent tester.

Standard Condition:
Intelligent Tester Operation Engine Condition
0% Normal engine speed
100% Engine idles roughly or stalls


If the operation is not as specified, check the oil control valve assembly, wire harness and ECM.



f.

Inspect the oil control valve assembly (for exhaust camshaft).

i.

Enter the following menus: Powertrain / Engine / Active Test / Control the VVT Exhaust Linear (Bank 1).

Powertrain > Engine > Active Test
Tester Display
Control the VVT Exhaust Linear (Bank1)
50004 234 87

ii.

Check the engine speed while operating the camshaft timing oil control valve assembly (for exhaust camshaft) using the intelligent tester.

Standard Condition:
Intelligent Tester Operation Engine Condition
0% Normal engine speed
100% Engine idles roughly or stalls


If the operation is not as specified, check the oil control valve assembly, wire harness and ECM.


iii.

Enter the following menus: Powertrain / Engine / Active Test / Control the VVT Exhaust Linear (Bank 2).

Powertrain > Engine > Active Test
Tester Display
Control the VVT Exhaust Linear (Bank2)
50004 234 88

iv.

Check the engine speed while operating the camshaft timing oil control valve assembly (for exhaust camshaft) using the intelligent tester.

Standard Condition:
Intelligent Tester Operation Engine Condition
0% Normal engine speed
100% Engine idles roughly or stalls


If the operation is not as specified, check the oil control valve assembly, wire harness and ECM.