Home › Engine / Hybrid System › 2GR-FE ENGINE CONTROL › THROTTLE BODY
RM2030EQ _51 Engine / Hybrid System _014634 2GR-FE ENGINE CONTROL _0074396 THROTTLE BODY G

2GR-FE ENGINE CONTROL  THROTTLE BODY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 22030 1.INSPECT THROTTLE WITH MOTOR BODY ASSEMBLY

a.

Check the throttle control motor operating sound.

i.

Turn the ignition switch to ON.


ii.

When depressing the accelerator pedal, check the operating sound of the motor. Make sure that no friction noises are emitted from the motor.

If friction noise exists, replace the throttle with motor body assembly.



b.

Check the throttle position sensor.

i.

Connect the intelligent tester to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the intelligent tester on.


iv.

Enter the following menus: Powertrain / Engine / Data List / Gas Throttle / Throttle Sensor Position.

Powertrain > Engine > Data List
Tester Display
Throttle Sensor Position
50003 234 12

v.

Depress the accelerator pedal. When the throttle valve is fully open, check that the Throttle Sensor Position value is within the specification.

Standard Throttle Valve Opening Percentage:
Tester Display Specified Condition
Throttle Sensor Position 60% or more


NOTICE:
·

When checking the throttle valve opening percentage, the shift lever should be in neutral.

·

Fully depress the accelerator pedal.



If the percentage is less than 60%, replace the throttle with motor body assembly.