Home › Engine / Hybrid System › 2GR-FE ENGINE CONTROL › VACUUM SWITCHING VALVE(for Engine Mounting)
RM2030EQ _51 Engine / Hybrid System _014634 2GR-FE ENGINE CONTROL _0074397 VACUUM SWITCHING VALVE(for Engine Mounting) G

2GR-FE ENGINE CONTROL  VACUUM SWITCHING VALVE(for Engine Mounting)  INSPECTION  


PROCEDURE

Hide 17650G 1.INSPECT DUTY VACUUM SWITCHING VALVE (OPERATION)

a.
A292396
1.656,0.354 1.813,0.552 0.156,0.198 10 G 2.208,1.302 2.365,1.5 0.156,0.198 10 E 1.802,1.646 1.958,1.844 0.156,0.198 10 F 1.583,1.875 1.74,2.073 0.156,0.198 10 H 2.615,1.885 2.771,2.083 0.156,0.198 10 G 3.104,2.615 3.26,2.813 0.156,0.198 10 E 3.177,2.875 3.333,3.073 0.156,0.198 10 F 2.563,3.063 2.719,3.26 0.156,0.198 10 H

Check the operation of the duty vacuum switching valve when positive battery voltage is applied to its terminals.

Standard Condition:
Condition Specified Condition
Battery voltage is not applied The air from pipe G is flowing out through pipes E and H.
Battery voltage is applied The air from pipe F is flowing out through pipes E and H.


If the result is not as specified, replace the duty vacuum switching valve.


Hide 17650G 2.INSPECT DUTY VACUUM SWITCHING VALVE (RESISTANCE)

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 19 to 21 Ω


If the resistance is not as specified, replace the duty vacuum switching valve.