Home › Engine / Hybrid System › 2GR-FE ENGINE CONTROL › VACUUM SWITCHING VALVE(for Engine Mounting)
RM2030EQ _51 Engine / Hybrid System _014634 2GR-FE ENGINE CONTROL _0074397 VACUUM SWITCHING VALVE(for Engine Mounting) A

2GR-FE ENGINE CONTROL  VACUUM SWITCHING VALVE(for Engine Mounting)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (- ) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 53851Z 2.REMOVE FRONT WHEEL OPENING EXTENSION PAD RH

Hide 51441C 3.REMOVE ENGINE UNDER COVER RH

Hide 53852K 4.REMOVE FRONT WHEEL OPENING EXTENSION PAD LH

Hide 51442C 5.REMOVE ENGINE UNDER COVER LH

Hide 6.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable from the negative (-) battery terminal, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 17650G 7.REMOVE DUTY VACUUM SWITCHING VALVE

a.
A254999

Disconnect the 2 vacuum hoses from the duty vacuum switching valve.


b.

Disconnect the hose.


c.
A255000

Remove the bolt and disconnect the duty vacuum switching valve connector.


d.

Disconnect the vacuum hose to remove the duty vacuum switching valve.