Home › Engine / Hybrid System › 2GR-FE ENGINE CONTROL › MASS AIR FLOW METER
RM2030EQ _51 Engine / Hybrid System _014634 2GR-FE ENGINE CONTROL _0074400 MASS AIR FLOW METER G

2GR-FE ENGINE CONTROL  MASS AIR FLOW METER  INSPECTION  


PROCEDURE

Hide 22204 1.INSPECT MASS AIR FLOW METER SUB-ASSEMBLY

a.
A154164
0.917,2.042 1.104,0.573 1.104,0.573 1.24,0.573 false 1.26,0.469 1.552,0.646 0.292,0.177 10 *a
*a Platinum Hot Wire (Heater)


Perform a visual check for any foreign matter on the platinum hot wire (heater) of the mass air flow meter shown in the illustration.

OK:

There is no foreign matter.


If the result is not as specified, replace the mass air flow meter.


b.
A127786
2.729,1.458 2.479,0.844 true 2.938,1.458 3.052,0.885 true 2.375,0.646 2.708,0.813 0.333,0.167 10 E2 2.969,0.656 3.302,0.813 0.333,0.156 10 THA 2.531,0.167 2.708,0.333 0.177,0.167 10 *a
*a Component without harness connected
(Mass Air Flow Meter)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (THA) - 2 (E2) -20°C (-4°F) 13.6 to 18.4 kΩ
1 (THA) - 2 (E2) 20°C (68°F) 2.21 to 2.69 kΩ
1 (THA) - 2 (E2) 60°C (140°F) 0.49 to 0.67 kΩ


If the result is not as specified, replace the mass air flow meter.