Home › Engine / Hybrid System › 2GR-FE ENGINE CONTROL › ENGINE COOLANT TEMPERATURE SENSOR
RM2030EQ _51 Engine / Hybrid System _014634 2GR-FE ENGINE CONTROL _0074404 ENGINE COOLANT TEMPERATURE SENSOR G

2GR-FE ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  INSPECTION  


PROCEDURE

Hide 89422 1.INSPECT ENGINE COOLANT TEMPERATURE SENSOR

a.
A183498
0.221,0.774 0.455,0.932 0.234,0.158 10 kΩ 2.76,4.024 3.002,4.21 0.242,0.186 10 °C 2.737,4.21 3.024,4.406 0.287,0.197 10 (°F)

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (E2) - 2 (THW) 20°C (68°F) 2.32 to 2.59 kΩ
1 (E2) - 2 (THW) 80°C (176°F) 0.310 to 0.326 kΩ


NOTICE:

If checking the sensor in water, be careful not to allow water to contact the terminals. After checking, wipe the water off the sensor.


If the result is not as specified, replace the engine coolant temperature sensor.