Home › Engine / Hybrid System › 2GR-FE ENGINE CONTROL › ACCELERATOR PEDAL
RM2030EQ _51 Engine / Hybrid System _014634 2GR-FE ENGINE CONTROL _0074409 ACCELERATOR PEDAL A

2GR-FE ENGINE CONTROL  ACCELERATOR PEDAL  INSTALLATION  


PROCEDURE

Hide 78110K 1.INSTALL ACCELERATOR PEDAL SENSOR ASSEMBLY

NOTICE:
·

Avoid physical shock to the accelerator pedal sensor assembly.

·

Do not disassemble the accelerator pedal sensor assembly.

·

The accelerator pedal sensor assembly does not require lubrication.

·

Do not apply oil or other lubricants to the accelerator pedal sensor assembly. If applied, the accelerator pedal sensor assembly must be replaced.



a.

Temporarily install the accelerator pedal sensor assembly with the 2 bolts.


b.
A254797
0.135,2.552 0.438,2.823 0.302,0.271 12 true *B 0.094,0.063 0.365,0.323 0.271,0.26 12 true *A 3.063,1.646 3.208,1.896 0.146,0.25 10 false 1 1.094,3.844 1.219,4.042 0.125,0.198 10 true 1 2.469,3.302 2.635,3.51 0.167,0.208 10 true 2 1.625,0.74 1.771,0.99 0.146,0.25 10 false 2
*A for LHD
*B for RHD


Tighten the 2 bolts in the order shown in the illustration.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


c.

Connect the accelerator pedal sensor assembly connector.