Home › Engine / Hybrid System › 2GR-FE ENGINE CONTROL › ACCELERATOR PEDAL
RM2030EQ _51 Engine / Hybrid System _014634 2GR-FE ENGINE CONTROL _0074409 ACCELERATOR PEDAL G

2GR-FE ENGINE CONTROL  ACCELERATOR PEDAL  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 78110K 1.CHECK ACCELERATOR PEDAL SENSOR ASSEMBLY

a.

Measure the voltage.

i.

Connect the intelligent tester to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the intelligent tester on.


iv.

Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Accel Sensor Out No. 1 and Accel Sensor Out No. 2.

Powertrain > Engine > Data List
Tester Display
Accel Sensor Out No.1
Accel Sensor Out No.2
50003 234 280,281

v.

Read the values displayed on the intelligent tester.

Standard Voltage:
Accelerator Pedal Operation Accel Sensor Out No. 1 Accel Sensor Out No. 2
Fully Released 0.5 to 1.1 V 1.2 to 2.0 V
Fully Depressed 2.6 to 4.5 V 3.4 to 4.98 V


If the results are not as specified, check the accelerator pedal sensor assembly, wire harness or ECM.